Starter Kit, Micro Mill 

This kit contains the basics you need to start using your new micro mill.

The clamping kit fits the 8 mm T-slots on the micro mill. The clamping kit includes10 M6 studs, 8 step block pairs, 6 T-slot nuts, 6 flange nuts, and 6 step clamps.

The thin parallels are a set of 10 matched pairs of high grade steel parallels, precision ground and hardened. The parallels are 1/8" thick and 3" long. The heights are 1/2", 5/8", 3/4", 7/8", 1", 1-1/8", 1-1/4", 1-3/8", 1-1/2", and 1-5/8".

They are made of high grade alloy steel hardened to 52 to 58 Rc and are parallel within 0.0002" on the top and bottom. The pairs are matched in height within 0.0004".

The precision 1-2-3 blocks are ground and case hardened on all sides to 50-60 Rc. The blocks are 1" by 2" by 3". They are parallel within 0.0002", flat within 0.0002" and square within 0.0002". Each set includes two matched blocks. The blocks have 23 holes through them, 5 are threaded 3/8"-16 NC.

The 3/8" diameter combination edge and center finder helps you locate work on your mill. The edge finder end has a 0.200" diameter cylinder to quickly find the edge of a work piece. The center finder end tapers to a point to locate holes. The edge and center finder is hardened and ground all over.